Mishimoto Mishimoto High-Performance -10AN Fuel Filter, 10-Micron Cellulose Insert - MMFF-ST-C010

Building a high-performance vehicle is an expensive endeavor that requires attention to every little detail. When horsepower is nearing the 4-digit mark, one oversight can cause catastrophic failure. Each vehicle system needs to be running at peak performance, but no other system can cause thousands of dollars of damage faster than fuel. An undersized or clogged fuel injector, pump, or filter can cause too little fuel flow to the engine, resulting in not only a loss of power, but also excessive heat. Even short periods of high cylinder temps can lead to detonation, melted pistons, or a seized engine and thousands of dollars in repairs. The best way to prevent fueling issues is to install the best quality components from tank to injector, and our Mishimoto high-performance fuel filters fit the bill. Our fuel filters utilize a high flow extruded-aluminum body with -10 ORB inlets and outlets to provide up to 198 GPH (750 LPH). These fuel filters feature an easy to replace cartridge-style filter in your choice of cellulose paper for petroleum-based fuels or welded stainless-steel for use with alcohol-based fuels. Both our cellulose and stainless-steel filters are available with a 10-micron rating for use between the pump and fuel rail, while the stainless-steel inserts are also available with a 100-micron rating for pre-pump filtering. Our filter inserts feature high-quality Viton O-rings and are rated to withstand up to 116 PSI for reliable performance on even the most demanding vehicles. Over 60 sq. in. of filter surface area protects valuable fuel pumps and injectors while allowing minimal pressure drop.

• Protects high-value fuel pumps and injectors from damage and clogging
• Over 60 sq. in. of surface area reduces risk of clogging and improves filtration
• 10-micron filters recommended between pump and fuel rail
• 100-micron filters recommended before fuel pump
• Mishimoto Lifetime Warranty
• Replaceable 100 and 10-micron filters for superior protection of vital fuel system components
• Flows up to 198 GPH (750 LPH) for high-horsepower builds
• Available with cellulous filter for petroleum-based fuels or reusable stainless-steel filter for alcohol-based fuels
• -10 ORB inlets ensure adequate fuel flow and low pressure drop in all situations
• Integrated mounted brackets for quick and easy installation
• Extruded and anodized aluminum body is lightweight and durable to withstand the rigors of racing
• Rated to withstand up to 116 PSI working fuel pressure
• High-quality Viton O-rings prevent leaking under high pressures